Moog-music Etherwave Plus Kit (Owner's Manual) User Manual

Browse online or download User Manual for Musical Instruments Moog-music Etherwave Plus Kit (Owner's Manual). Moog Music Etherwave Plus Kit (Owner's Manual) User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Moog Music Inc.
554C Riverside Drive
Asheville, NC 28801
SETTING UP AND PLAYING THE MOOG
ETHERWAVE
THEREMIN
INTRODUCTION
The theremin is an electronic musical instru-
ment played by the free movement of the
performer's hands in the space surrounding it.
This method of playing gives the theremin tone
its unique ethereal and dramatic quality, while
at the same time allowing the performer a
measure of artistic freedom that other musical
instruments do not offer. The techniques of
playing the theremin can be mastered by
anyone who has a good musical ear, and who
is willing to invest a modest amount of
practicing time. Two motions are involved.
Movement of the right hand toward the pitch
antenna controls pitch, while movement of the
left hand toward the volume antenna controls
loudness or volume.
The Moog ETHERWAVE theremin is powered by
a special adapter which plugs into a standard
110-125 volt grounding power outlet. It is
designed to operate with a wide range of
amplifier-speaker combinations.
PREPARING THE
ETHERWAVE
THEREMIN FOR
PLAYING
Your ETHERWAVE theremin is completely
assembled. Only the following preparations for
playing are necessary: a) Placing the
instrument on a stand, b) attaching the two
antennas, c) connecting the power adapter,
d) connecting the amplifier-speaker with an
audio cord, and e) setting the panel
adjustments. Each of these steps will now be
described in detail. Note that the steps of
preparation are listed in the order in which they
are to be executed.
a) Placing the instrument on a stand: The
ETHERWAVE theremin requires either a standard
microphone stand (preferred) or a small table
36" to 42" high. If a table is used, no objects on
the table should be within a foot or two of the
theremin, and the theremin itself should be
positioned so that the the volume antenna will
overhang the edge of the table. Whichever
type of stand is used, the ETHERWAVE should be
securely mounted, and away from walls and
other large stationary objects.
b) Attaching the two antennas: The pitch
antenna, which is the long straight tube, is
placed in the elbow (right angle) fitting on the
right end of the instrument, with the brass
compression ring down. The mounting nut is
slipped over the antenna and screwed onto
the fitting. The nut need be only finger-tight, but
should be tight enough so that the antenna is
firmly in place.
The volume antenna, which is the tubular loop,
is placed in the straight fittings on the left end
of the instrument, with the bulge in the loop
facing forward and down. The mounting nuts
already on the antenna are screwed onto the
fittings. The nuts need be only finger-tight, but
should be tight enough so that the antenna is
firmly in place.
c) Connecting the power adaptor: The
ETHERWAVE
is powered by a special adaptor
which is grounded to the power ground and
which supplies 14 volts AC to the
ETHER-WAVE
Page view 0
1 2 3 4

Summary of Contents

Page 1 - THEREMIN

Moog Music Inc.554C Riverside DriveAsheville, NC 28801SETTING UP AND PLAYING THE MOOG ETHERWAVE  THEREMININTRODUCTIONThe theremin is an electronic mu

Page 2 - ETHERWAVE THEREMIN

itself. Plug the round three-pin 'DIN' connectoron the adapter cable into the mating powersocket on the back side of the ETHERWAVE.(That&apo

Page 3

BRIGHTNESS knobs. The WAVEFORM knobadjusts which harmonics are strong and whichare weak, while the BRIGHTNESS knob adjuststhe overall amount of harmon

Page 4 - MAINTENANCE

Once you've mastered the basic moves, it willbe time for you to develop your own style. Payparticular attention to shaping envelopes anddynamics

Comments to this Manuals

No comments