Moog-music Minimoog Voyager Performer Edition User Manual download pdf (Page 56)

Page 58

Voyager User’s Manual - EDIT Mode

Page 59

Voyager User’s Manual - EDIT Mode

5.2 T.S. MEM MOD BUS (Touch Surface Memory Modulation Bus)

The TS MEM MOD BUS function is for allowing the last known X and

Y parameters of the Touch Surface inputs to be held in memory after

contact is no longer made with the touch surface. The held values only

apply to those used as the programmable Sources in the Mod Busses,

however. When this function is off, the X and Y values return to zero after

contact with the touch surface is no longer made.

5.3 T. S. MEMORY GLOBAL (Touch Surface Memory Global)

The TS MEMORY GLOBAL function adds memory to the direct

destinations of Touch Surface X and Y inputs. When the Touch

Surface Gate input goes off after being on, the last X and Y values are

remembered until the next time the Gate goes on.

5.4 POT MAPPING S/D (Pot Mapping Source and Destinations)

The POT MAPPING S/D function allows up to four separate modulation

routings, independent of the Mod Busses. In Pot Mapping, the

programmable modulation sources and destinations can be performance

controls (like Pitch Bend or Velocity), or front panel controls (like the LFO

Rate control). Each of the four mappings has it own dedicated menu. Use

the -1/+1 buttons to select the desired map and then press ENTER.

A new menu will appear, similar to the one shown at left for Pot Map 3.

All four map menus are identical and have the same assignable options.

The menu allows you to select the source (SRC), the destination (DEST.),

the direction, and the amount for each of the four mappings. Use the

CURSOR to move to the desired parameter, then use the -1/+1 buttons

to select the desired value.

TS GATE (con’t)

The LFO Restart function is the fourth option in the TS Gate Con-

trol menu. Since the TS Gate Control menu can only display three

options at a time, use the CURSOR to scroll down to the bottom

of the list, where the LFO Restart option will appear.

Use the -1/+1 buttons to switch the LFO Restart function ON or

OFF. When LFO Restart is ON, a Gate ON signal applied to the TS

GATE input on the VX-352 will restart the LFO, generating a new

sample based on the voltages at the TS X,Y, and A inputs of the

VX-352. (Note: For the Gate LFO Restart function to operate, the

front panel LFO SYNC control must be set to “MIDI” when the LFO

Restart function is switched ‘ON’.)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 115 116

No comments

Moog-music Minimoog Voyager Performer Edition User Manual Page 56