Moog-music Minimoog Voyager Performer Edition User Manual Page 70

  • Download
  • Add to my manuals
  • Print
  • Page
    / 116
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 69
Page 72
Voyager User’s Manual - MASTER Mode Factory Setups
Page 73
Voyager User’s Manual - MASTER Mode Factory Setups
2.3 CLOCK DIVIDER
The CLOCK DIVIDER function restores the default settings
for the clock divider parameter stored in the presets. The
default value is 24, which is an 8
th
note (half a beat). To restore
the clock divider values to their defaults, , use the CURSOR
to select ‘YES’ and press ENTER. To leave this menu without
changes, select ‘NO’ and press ENTER.
Map 1-
SRC: Mod Wheel
Dest: Pedal Amt
Direction: Normal
Amount: 50%
Map 2 -
SRC: Key Pitch
Dest: Fil Spacing
Direction: Inverse
Amount: 50%
Map 3 -
SRC: Mod Wheel
Dest: Fil Spacing
Direction: Normal
Amount: OFF
Map 4 - MOD 1
SRC: Key Pitch
Dest: Fil Cutoff
Direction: Normal
Amount: OFF
To restore the Pot Mapping default values, use the CURSOR
to select ‘YES’ and press ENTER. To leave this menu without
changes, select ‘NO’ and press ENTER.
2.2 SHAPING 1&2
The SHAPING 1&2 function restores the default settings for the
Programmable Mod Buss Shaping Sources. The defaults for both
sources are:
Shaping Source: Fixed Value
Offset Value (High): 0
Offset Value (Low): 0
To restore the Shaping Source default values, use the CURSOR
to select ‘YES’ and press ENTER. To leave this menu without
changes, select ‘NO’ and press ENTER.
2.2 POT MAPPING
The POT MAPPING function restores the default settings for
the Pot Mapping parameters stored in the presets. The default
values are:
2.1 T.S. XYAG S&H (Touch Surface XYAG Sample & Hold)
The T.S. XYAG S&H function sets the Touch Surface LFO Sample
& Hold parameter to “OFF” for all Presets in the current bank
(other banks are not affected). To reset the T.S. XYAG S&H,
select ‘YES’ and press ENTER. To escape without changes, select
‘NO’ and press ENTER.
Page view 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 115 116

Comments to this Manuals

No comments